DTC Confirmation Procedure

If DTC Confirmation Procedure has been previously conducted, always perform the following procedure before conducting the next test.

1. Turn ignition switch OFF and wait at least 10 seconds.
2. Turn ignition switch ON.
3. Turn ignition switch OFF and wait at least 10 seconds.

GO TO STEP 2  .

With CONSULT

1. Turn ignition switch ON.
2. Select "DATA MONITOR" mode of "ENGINE" using CONSULT.
3. Check "COOLANT TEMP/S".

With GST

Follow the procedure "With CONSULT" above.

Is it above - 6°C [21°F (for CVT)] or 5°C [41°F (for M/T)]?

YES 

INSPECTION END

NO 

GO TO STEP 3  .

With CONSULT

1. Start engine and run it for 65 minutes at idle speed.
2. Check 1st tip DTC.

If "COOLANT TEMP/S" indication increases to more than 10°C (50°F) within 65 minutes, stop engine because the test result will be OK. 

With GST

Follow the procedure "With CONSULT" above.

Is 1st trip DTC detected?

YES 

Proceed to DIAGNOSIS PROCEDURE .

NO 

INSPECTION END