Work Procedure

There is no vehicle specification in the new IPDM E/R, so the vehicle specification needs to be written in IPDM E/R with CONSULT.

Configuration has three functions as follows.

Function		Description
Before ECU Replacement		Reads the vehicle configuration of current IPDM E/R Saves the read vehicle configuration
After ECU Replacement	FAST linked	NOTE: This item is displayed, but cannot be used
	Manual selection	Writes the vehicle configuration with manual selection.

CAUTION: Never perform vehicle configuration other than performing with a new IPDM E/R or the control function may not operate normally.

WRITING MODE SELECTION
CONSULT

Reads the vehicle specification.

When writing saved data (able to be read)

GO TO 2.

When writing manually (could not be read)

GO TO 3.
PERFORM WRITING SAVED DATA
CONSULT
1. Ignition switch ON.
2. Select "Re/programming, Configuration". Select the vehicle specifications saved with "Before ECU Replacement" and then write them to the replacement IPDM E/R.
GO TO 5.
PERFORM WRITING MANUALLY (IPDM E/R)
CONSULT
1. Ignition switch ON.
2. Select the "IPDM E/R" of "Re/programming, Configuration".
3. Select the "Type ID" searched by using FAST (service parts catalogue) to write the "Type ID" into the IPDM E/R.
  CAUTION: Check the "Type ID" accurately. If the "Type ID" is selected incorrectly, ECU control may not function normally.
GO TO 4
OPERATION CHECK
Confirm that each function controlled by IPDM E/R operates normally.

Work End.