Work Procedure

BEFORE REPLACING CHASSIS CONTROL MODULE 

1. SAVE "OPERATION LOG" 
   1. With CONSULT: Save "Operation Log", according to the procedure of "Programming" in CONSULT Operation Manual.
      NOTE: Chassis control module part number is saved in "Operating Log" saved in CONSULT.

   >>

   • Replace the chassis control module. Refer to Removal and Installation .
   • After replacing the chassis control module, perform necessary work.

AFTER REPLACING CHASSIS CONTROL MODULE 

1. CHECK "OPERATION LOG" 
   1. With CONSULT: Check "Operation Log" saved before replacing the chassis control module, according to the procedure of "Programming" in CONSULT Operation Manual.
      NOTE: For the vehicle that the programming is to be performed, check if "Operation Log" of Vehicle Identification Number (VIN) is in Saved Data List.

   Is there an applicable Operation Log in the Saved Data List?

   YES>>

   GO TO 2.

   NO>>

   GO TO 3.

2. PERFORM CHASSIS CONTROL MODULE PROGRAMMING 
   1. With CONSULT: Perform chassis control module programming, according to "Programming" of CONSULT Operation Manual. Refer to CONSULT Operation Manual.
      CAUTION:

      During programming, maintain the following conditions:

      • Ignition switch: ON
      • Electric load: OFF
      • Brake pedal: Not depressed
      • 12 V battery voltage: 12 - 13.5 V (Check the value displayed on the CONSULT screen.)

   >>

   GO TO 5.

3. READ IN CHASSIS CONTROL MODULE PART NUMBER BY EPC LINKED 
   1. Obtain chassis control module part number by EPC (service parts catalog), according to the procedure of EPC linked in CONSULT Operation Manual. Refer to CONSULT Operation Manual.
      CAUTION:

      Be sue select "EPC linked".

      NOTE: "EPC linked" allows an appropriate programming by obtaining ECU part number from EPC (service parts catalog) even when the part number cannot be obtained from the old ECU used before replacing with a new one.

   >>

   GO TO 4.

4. PERFORM PROGRAMMING (EPC LINKED) 
   1. With CONSULT: Perform chassis control module programming according to the procedure of EPC linked in CONSULT Operation Manual. Refer to CONSULT Operation Manual.
      CAUTION:

      During programming, maintain the following conditions:

      • Ignition switch: ON
      • Electric load: OFF
      • Brake pedal: Not depressed
      • 12 V battery voltage: 12 - 13.5 V (Check the value displayed on the CONSULT screen.)

   >>

   GO TO 5.

5. PERFORM NECESSARY WORK 
   1. 1. Perform self-diagnosis for "CHASSIS CONTROL".
      2. Erase the memory of self-diagnosis results.

   >>

   End of work.