Component Inspection

1. 1. Turn ignition switch OFF.
   2. Disconnect brake pedal position harness connector.
   3. Check the continuity between brake pedal position switch terminals as per the following conditions.

      Brake pedal position switch		Condition		Continuity
      Terminal
      1	2	Brake pedal	Fully released	Existed
      			Slightly depressed	Not existed

Is the inspection result normal?

YES>>

INSPECTION END

NO>>

GO TO 2.

1. 1. Adjust brake pedal position switch installation. Refer to Removal and Installation .
   2. Check the continuity between brake pedal position switch terminals as per the following conditions.

      Brake pedal position switch		Condition		Continuity
      Terminal
      1	2	Brake pedal	Fully released	Existed
      			Slightly depressed	Not existed

Is the inspection result normal?

YES>>

INSPECTION END

NO>>

Replace brake pedal position switch. Refer to Removal and Installation .