Component Inspection

1. 1. Turn ignition switch OFF.
   2. Disconnect high pressure fuel pump harness connector.
   3. Check the resistance between high pressure fuel pump terminals as per the following conditions.

      High pressure fuel pump		Condition		Resistance
      Terminal
      1	2	Temperature [°C (°F)]	20 - 30 (68 - 86)	0.46 - 0.51 Ω

Is the inspection result normal?

YES>>

GO TO 2.

NO>>

Replace high pressure fuel pump. Refer to Exploded View .

1. With CONSULT:
   1. Reconnect high pressure fuel pump harness connector.
   2. Start engine.
   3. Select "FUEL PRES SEN V" in "DATA MONITOR" mode of "ENGINE" using CONSULT and check the indication as per the following conditions.

      Monitor item	Condition	Indication
      FUEL PRES SEN V	At idle	0.820 - 1.140 V
      	Revving engine up to 4, 000 RPM quickly.	0.820 - 2.900 V

2. Without CONSULT
   1. Start engine.
   2. Check fuel rail pressure sensor signal voltage.

   ECM			Condition	Voltage (Approx.)
   Connector	+	-
   	Terminal
   F24	44	45	[Engine is running] Warm-up condition Idle speed	0.82 - 1.14 V
   			[Engine is running] Warm-up condition Engine speed: Revving engine from idle to 4, 000 RPM	0.82 - 2.90 V

Is the inspection result normal?

YES>>

INSPECTION END

NO>>

Replace high pressure fuel pump. Refer to Exploded View .