Component Function Check

1. Make sure that all of the following conditions are satisfied.
   • Vehicle driven distance: More than 5, 000 km (3, 107 miles)
   • Atmospheric pressure: 98.3 - 104.3 kPa (1.003 - 1.064 kg/cm2, 14.25 - 15.12 psi)
   • Atmospheric temperature: 20 - 30°C (68 - 86°F)
   • Engine coolant temperature: 75 - 95°C (167 - 203°F)
   • Transmission: Warmed-up
     • After the engine is warmed up to normal operating temperature, drive vehicle until "ATF TEMP SEN" (CVT fluid temperature sensor signal) indicates more than 60°C (140°F).
   • Electrical load: Not applied*
   • Engine speed: Idle

   *: Rear window defogger switch, air conditioner switch, lighting switch are OFF. Steering wheel is straight ahead.

>>

GO TO 2.

1. With CONSULT:
   NOTE: Perform "Reference" in "DATA MONITOR" mode in maximum scale display.
   1. Refer to Work Procedure .
   2. On CONSULT screen, select "ENGINE">>"Data Monitor".
   3. Select "Reference" and change "DISPLAY TYPE" to "Line Graph".
   4. Select "B/FUEL SCHDL", "A/F ALPHA-B1" and "MASS AIR FLOW SENSOR (Hz)".
   5. Make sure that monitor items are within the SP value.

Is the inspection result normal?

YES>>

END

NO>>

Refer to Diagnosis Procedure .