Component Inspection

1. 1. Turn ignition switch OFF.
   2. Loosen the fixing bolt of the sensor.
   3. Disconnect camshaft position sensor (PHASE) harness connector.
   4. Remove the sensor.
   5. Visually check the sensor for chipping.

      Courtesy of NISSAN

Is the inspection result normal?

YES>>

GO TO 2.

NO>>

Replace camshaft position sensor (PHASE). Refer to Exploded View .

1. Check resistance camshaft position sensor (PHASE) terminals as follows.

   CMP sensor		Condition		Resistance
   Terminal
   1	2	Temperature	25°C (77°F)	Except 0 Ω
   	3
   2	3

Is the inspection result normal?

YES>>

INSPECTION END

NO>>

Replace camshaft position sensor (PHASE). Refer to Exploded View .