Component Inspection
- CHECK CAMSHAFT POSITION SENSOR (PHASE)-1
- Turn ignition switch OFF.
- Loosen the fixing bolt of the sensor.
- Disconnect camshaft position sensor (PHASE) harness connector.
- Remove the sensor.
- Visually check the sensor for chipping.
Is the inspection result normal?
>>
GO TO 2.
>>
Replace camshaft position sensor (PHASE). Refer to Exploded View .
- CHECK CAMSHAFT POSITION SENSOR (PHASE)-2
Check resistance camshaft position sensor (PHASE) terminals as follows.
CMP sensor Condition Resistance Terminal 1 2 Temperature 25°C (77°F) Except 0 Ω 3 2 3 Is the inspection result normal?
>>
INSPECTION END
>>
Replace camshaft position sensor (PHASE). Refer to Exploded View .