LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Pontiac >> 2008 >> G6 Base, 2.4 B >> Repair and Diagnosis >> Engine Performance >> System >> Engine Control System & Fuel System - 2.4L - DTC P0351 To DTC P2544 >> DTC P0351-P0354 >> Circuit/System Testing
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Circuit/System Testing

  1. Ignition OFF, disconnect the harness connector at the affected ignition coil/module.
  2. Ignition OFF for 90 seconds, disconnect the ECM connector X2.
  3. Test for an open, a high resistance, a short to ground and for a short to voltage between the ignition coil/module IC circuit terminal C and the appropriate ECM terminal listed below:
    • IC 1 circuit: terminal 1
    • IC 2 circuit: terminal 53
    • IC 3 circuit: terminal 17
    • IC 4 circuit: terminal 33
    • If a fault is found, repair the circuit as needed.
  4. Connect the ECM.
  5. Exchange the affected ignition coil/module with the ignition/coil module of a good cylinder.
  6. Start the engine and observe the scan tool.
    • If the DTC or the misfire transfers with the suspect ignition/coil module, replace as needed.
    • If the DTC or the misfire does not transfer with the suspect ignition/coil module, replace the ECM.
scientia non olet · About LEMON Manuals