LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Saab >> 2007 >> 9-5 4D Sedan, Standard >> Repair and Diagnosis >> Brakes >> Traction Control >> Stabilizer System, Esp >> Repair Instructions >> ESP Unit With Control Module >> To fit
April 5, 2026: LEMON Manuals is launched! Read the announcement.

To fit

  1. Make sure the rubber plug is inserted in the ESP unit's bracket on the structural member.
  2. Fit the ESP unit.

    Tightening torque: 24 Nm (18 lbf ft) 

    Fig 1: Illustration For Steps 2-4
    G05041143Courtesy of SAAB-SCANIA OF AMERICA, INC.
  3. Fit the brake pipes that run to the wheel cylinders. Thread the nipples by hand.
  4. Tighten the nipples with a brake pipe wrench.

    Tightening torque: 15 Nm (11 lbf ft) 

    Fit the brake pipes that run to the master cylinder.

    Tightening torque: 15 Nm (11 lbf ft) 

  5. Plug in the connector.
    Fig 2: Illustration For Steps 5-6
    G05041144Courtesy of SAAB-SCANIA OF AMERICA, INC.
  6. Fit the electrical distribution unit.
  7. V6 diesel engine:  Fit the turbocharger heat shield.
  8. Bleed the brake system, see BLEEDING THE BRAKE SYSTEM .
  9. If the unit is changed:  Connect the diagnostic tool and configure the unit.
  10. Perform SPARE PARTS PROGRAMMING, ESP .
scientia non olet · About LEMON Manuals