Switch - Power Window Sub Front

Measure the resistance between terminals of the switch - power window sub front.

Preparation tool:

Circuit tester

Courtesy of SUBARU OF AMERICA, INC.

Passenger's seat sub

Terminal No.	Inspection conditions	Standard
6 - 5 6 - 7	OFF	Less than 1 Ω
2 - 5 2 - 6	OFF	1 MΩ or more
2 - 6 5 - 7	Manual UP	Less than 1 Ω
2 - 5 6 - 7	Manual UP	1 MΩ or more
2 - 5 6 - 7	Manual DOWN	Less than 1 Ω
2 - 6 5 - 7	Manual DOWN	1 MΩ or more

Apply battery voltage between the switch - power window sub front terminals to check lighting condition of illumination inside the switch.

CAUTION: When applying battery voltage, make sure that each polarity (positive (+) and negative (-)) is properly connected.
Incorrect polarity connection may cause LED damage inside the switch.

Terminal No.	Inspection conditions	Standard
7 (+) - 2 (-)	Apply battery voltage.	Light ON

Replace the switch - power window sub front if it is found defective from the inspection result.