Section 272 (Charging System - Generators & Regulators): Generator: Installation

WARNING: This page is about a different car, the 2002 Toyota MR2. However, it is still accessible from the selected car via links, so may be relevant.

Install Generator
1. Install the 2 bolts and generator.
  1. Torque:
  2. 12 mm head: 25 N.m (255 kgf.cm, 18 ft.lbf)
  3. 14 mm head: 54 N.m (550 kgf.cm, 40 ft.lbf)
  Fig 1: Displaying Bolts & Generator
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Connect the wire clamp to the wire clip on the rectifire end flame.
3. Connect the generator connector.
4. Connect the generator wire, and install the nut and cap.

Fig 2: Displaying Connecting Steps

Install RH Engine Mounting Insulator . See INSTALLATION .
Install Drive Belt
Turning the drive belt tensioner clockwise, and install the drive belt.

Fig 3: Installing Drive Belt
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002