Inspect Wireless Door Lock Control Functions
The switch described in this text is a switch for transmission (LOCK switch, UNLOCK switch and PANIC switch), which is built in the door control transmitter.
- Allow the vehicle to be in the initial condition (condition that the wireless control is possible). The followings are the vehicle's initial condition.
- No key in the ignition key cylinder
- All the doors closed (door open indicator off)
- All the doors locked
- Check the basic function.
- If the LED does not light up when the switch has been pressed 3 times or more, it may be caused by the dead battery.
- If the switch is kept pressed, the LED blinks continuously.
- Check whether the LED of the transmitter lights up 3 times when each switch is pressed 3 times.
- In the remote control operational area, check that all the doors will be locked when the LOCK switch is pressed. (However, this will not happen when the key is in the ignition key cylinder or any of the doors is open.)
- The UNLOCK operation is possible even when any of the doors is open.
- If the 2-unlock operation is set in the setting mode of a transmitter, the unlock operation is not carried out as specified in step (3) but carried out as follows:
Only the driver's door will be unlocked when the UNLOCK switch is pressed once, and the other door will be unlocked when the UNLOCK switch is pressed again within 3 seconds. (However, this will not happen when the key is in the ignition key cylinder.)
- In the remote control operational area, check that all the doors will be unlocked when the UNLOCK switch is pressed. (However, this will not happen when the key is in the ignition key cylinder.)
NOTE:NOTE: - Check the chattering prevention function.
Check that the corresponding operation will be performed only once but not repeated continuously when the switch has been kept pressed. However, if the operations are carried out by approximately 1 second interval, from the time to release the switch until the time to press it again, check that the corresponding operation to the switch pressed next will be carried out.
- Check the automatic locking function.
- Check that all the doors will be automatically locked as long as any of the doors has not been opened or all the doors have not been locked within approximately 30 seconds after all the doors are unlocked by pressing the switch.
- Check that the automatic locking function will not work if any of the doors has been opened or all the doors have been locked within approximately 30 seconds after all the doors are unlocked by pressing the switch.
- Check the switch operation fail-safe function.
Check that the doors are not locked or unlocked by pressing the switch while the ignition key is in the ignition key cylinder. However, the time of the recognition code registration mode is excepted.
- Check the operation stop function when a door is open or not completely closed.
Check that the doors are not locked by pressing the switch while any of the doors is open or not completely closed.
- Check the repeat function.
After the LOCK switch has been pressed while the move of the driver's door control knob, which is in unlocking state, is being blocked forcibly, check that all the doors will be automatically locked once again in 2 seconds.
- Check the taillights and parking lights flashing and TVIP buzzer chirp function (answerback).
- When the LOCK switch is pressed, check that the taillights and parking lights will flash once and the TVIP buzzer will chirp once, simultaneously with all the doors locking operation.
- When the UNLOCK switch is pressed, check that the taillights and parking lights will flash twice, the TVIP buzzer will chirp twice and the interior light will remain on for 30 seconds, simultaneously with all the doors unlocking operation.
- Check the remote panic function.
Check that the horn will sound, the headlights, taillights and parking lights will flash, and the interior light will remain on for 60 seconds by the theft alarm function, when the PANIC switch is pressed. And, check that the horn sounding and lights flashing will stop when the either of the PANIC, LOCK or UNLOCK switch is pressed or the door is either locked or unlocked using the key. (However, this will not happen when the key is in the ignition key cylinder.)