Starter Motor - Installation

INSTALLATION





1. Install starter (4) and starter bolts (1). Tighten bolts to 42 Nm (31 ft. lbs.).
2. Connect B+ cable and nut. Tighten nut to 14 Nm (10 ft. lbs.).
3. Install the starter positive cable protective plastic cap (3).
4. Install the right side exhaust pipe, Catalytic Converter - Installation.
5. Connect the right side O2 sensor.
6. Install the lower engine panel.
7. Lower the vehicle.
8. Connect the negative battery cable and tighten nut to 7 Nm (60 in. lbs.).