Front Display Interface Module (FDIM)

Front Display Interface Module (FDIM)









Removal and Installation

1. NOTE: Module configuration is only required if a new Front Display Interface Module (FDIM) is being installed.

Upload the FDIM configuration information to the scan tool. For additional information, refer to Programmable Module Installation (PMI) in Module Configuration Programmable Module Installation (PMI).

2. Remove the instrument panel upper finish panel by pulling straight up.

3. Remove the 3 FDIM screws.

4. Remove the FDIM.
- Disconnect the electrical connector.

5. To install, reverse the removal procedure.
- Download the configuration information to the FDIM. For additional information, refer to PMI in Module Configuration Programmable Module Installation (PMI).