Parking Assist Control Module: Service and Repair

Parking Aid Module (PAM)









Removal and Installation

1. NOTE: Module configuration is only required if a new Parking Aid Module (PAM) is being installed.

Upload the PAM configuration information to the scan tool. For additional information, refer to PMI in Module Configuration Programmable Module Installation (PMI).

2. Remove the LH rear seat bolster. For additional information, refer to Seating Seat Bolster - Rear.

3. Remove the 2 screws and the PAM.
- Disconnect the electrical connectors.

4. To install, reverse the removal procedure.
- Download the PAM configuration information. For additional information, refer to Module Configuration [1][2]Initial Inspection and Diagnostic Overview.