License Plate Lamp: Service and Repair

LICENSE PLATE LIGHT REMOVAL/INSTALLATION

1. Disconnect the negative battery cable. Removal and Replacement Removal and Replacement Removal and Replacement

2. Remove the lens. Service and Repair

3. Insert a tape-wrapped fastener remover to the position shown in the figure, release the tabs.






4. Pull the rear bumper in the direction of the arrow (1) in the figure, and pull out the license plate lights in the direction of the arrow (2).






5. Pull out the wiring harness in the direction of the arrow and set it aside from the hook.






6. Remove the license plate light.

7. Install in the reverse order of removal.