Ignition Coil: Service and Repair

Ignition Coil Replacement

Removal Procedure





1. Remove the intake manifold cover. Refer to Intake Manifold Cover Replacement (Service and Repair).
2. Disconnect the engine wiring harness electrical connectors (1) from the ignition coil(s) (2).




3. Remove the ignition coil bolt(s).
4. Remove the ignition coil(s).



Installation Procedure





1. Install the ignition coil(s).
Notice: Refer to Fastener Notice (Fastener Notice).


2. Install the ignition coil bolt(s).

Tighten the bolt(s) to 10 N.m (89 lb in).





3. Connect the engine wiring harness electrical connector(s) (1) to the ignition coil(s) (2).
4. Install the intake manifold cover. Refer to Intake Manifold Cover Replacement (Service and Repair).