LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Acura >> 1991 >> Integra RS, 2D Hatchback, Automatic >> Repair and Diagnosis >> Engine Performance >> System >> Engine Controls - Tests W/Codes >> Code 17: Vehicle Speed Sensor (VSS)
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Code 17: Vehicle Speed Sensor (VSS)

NOTE: For wiring diagrams, see WIRING DIAGRAMS article in the ENGINE PERFORMANCE Section. For vacuum diagrams, see VACUUM DIAGRAMS article in the ENGINE PERFORMANCE Section.
  1. Turn ignition off. Remove HAZARD fuse in main fuse box for 10 seconds to reset ECU. Road test vehicle. With transmission in 2nd gear, accelerate to 3500 RPM and decelerate to 1500 RPM with throttle fully closed. Verify if CHECK ENGINE light comes on and if LED indicates Code 17. If LED does not indicate Code 17, problem is intermittent. Check for poor connections and loose wires at VSS connector.
  2. If lights are on, block rear wheels, and set parking brake. Raise front of vehicle, and support with safety stands. Connect ECU test harness between ECU and ECU connector.
  3. Turn ignition on. Slowly rotate left front wheel and measure voltage between ECU terminals B16 (positive) and A18 (negative). See Figure . If voltage does not pulse between 0-5 volts, check for open or short in Yellow/Red wire between ECU terminal B16 (positive) and VSS. If wire is okay, replace VSS. If VSS is okay, replace ECU.
  4. If voltage pulses between 0 and 5 volts, substitute a known good ECU, and recheck. If condition goes away, replace ECU.