LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Acura >> 1992 >> Legend Base, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 8 (Engine Controls - System/Component Tests) >> Idle Control System >> EACV
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Idle Control System: EACV

WARNING: This page is about a different car, the 1991 Acura Legend. However, it is still accessible from the selected car via links, so may be relevant.
  1. Turn engine off, and disconnect 2-wire connector on EACV. Measure resistance between both terminals on EACV. Replace EACV if resistance is not 8-15 ohms. If resistance is okay, check each terminal for continuity to ground. If continuity is present, replace EACV.
  2. If continuity is not present, turn ignition on. Measure voltage between Black/Yellow and Blue/Red wire terminals of EACV connector. If battery voltage is not present, go to next step.
  3. If battery voltage is not present, repair open in Black/Yellow wire between EACV connector and main relay located on left side of firewall. If battery voltage is present, connect PGM-FI test harness connector "A" to main wire harness only; DO NOT  connect to ECU.
  4. Connect and disconnect jumper wire between terminals A9 and A26. If EACV does not click, replace EACV. If EACV clicks, substitute a known good EACV, and recheck symptom.
scientia non olet · About LEMON Manuals