A/T Gear Position Switch
NOTE:
The A/T gear position switch also contains back-up light switch and neutral position switch. Back-up light switch and neutral position switch can also be checked when checking A/T gear position switch.
- Remove center console. Disconnect 14-pin electrical connector from A/T gear position switch. Note electrical connector terminal identification. See Fig 1 .
- Using ohmmeter, check continuity between specified terminal(s) with shift lever in indicated positions. See A/T GEAR POSITION SWITCH CONTINUITY
table.NOTE: Check continuity while moving shift lever back and forth in free play area of each gear position. DO NOT touch push button on shift lever when checking continuity.
- If continuity is not as specified, A/T gear position switch may require adjustment. See A/T GEAR POSITION SWITCH under REMOVAL & INSTALLATION. If correct continuity cannot be obtained by adjusting A/T gear position switch, replace switch assembly.
A/T GEAR POSITION SWITCH CONTINUITY
| Application | Shift Lever Position | Continuity Between Terminals | |
|---|---|---|---|
| With Cruise Control | |||
| A/T Gear Position Switch | "P" | A & L | |
| ..... | "R" | A & M | |
| ..... | "N" | A & N | |
| ..... | "D4" | I, A & G | |
| ..... | "D" | I, A & F | |
| ..... | "2" | I, A & E | |
| ..... | "1" | A & B | |
| Back-Up Light Switch | "R" | C & D | |
| Neutral Position Switch | "P" | J & K | |
| ..... | "N" | J & K | |
| Without Cruise Control | |||
| A/T Gear Position Switch | "P" | A & L | |
| ..... | "R" | A & M | |
| ..... | "N" | A & N | |
| ..... | "D4" | A & G | |
| ..... | "D" | A & F | |
| ..... | "2" | A & E | |
| ..... | "1" | A & B | |
| Back-Up Light Switch | "R" | C & D | |
| Neutral Position Switch | "P" | J & K | |
| ..... | "N" | J & K | |