LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Acura >> 1996 >> Integra GS-R, 2D Coupe >> Repair and Diagnosis >> Engine Performance >> Engine Controls - Adjustments >> Adjustment >> Ignition Timing >> Checking Ignition Timing
October 30: LEMON manuals on a temporary server, it is slow and having issues, download the manuals you need! Later in November we will switch back to the fast server.

Checking Ignition Timing

  1. Operate engine until cooling fan comes on. Locate 2-pin service check connector (behind right kick panel). Plug Service Check Connector Tool (07PAZ-0010100 ), into service check connector. Refer to Fig 1 .
  2. Connect inductive timing light to No. 1 spark plug wire. Ensure idle speed is 700-800 RPM. Red (16° BTDC) mark on crankshaft pulley should align with pointer on timing belt cover. If Red mark and pointer are not aligned, adjust base ignition timing by turning distributor. See IGNITION TIMING  . Remove service check connector tool from service check connector.
    Fig 1: Installing Service Check Connector Tool
    G96C01345Courtesy of AMERICAN HONDA MOTOR CO., INC.
    Fig 2: Identifying Ignition Timing Marks
    G93A78063Courtesy of AMERICAN HONDA MOTOR CO., INC.
    IGNITION TIMING (1) (Degrees BTDC RPM)

    Application (2) Man. Trans. (3) Auto. Trans.
    Integra 14-18 700-800 14-18 700-800
    (1) Service Check Connector Tool (07PAZ-0010100 ) must be installed before checking timing.
    (2) Manual transmission in Neutral.
    (3) Automatic transmission in Neutral or Park.
scientia non olet · About LEMON Manuals