Programming and Relearning

EEPROM Programming
1. Set-up - Ensure that the following conditions have been met:
^ The battery is fully charged.
^ The ignition is "ON."
^ The Vehicle Interface Module cable connection at the DLC is secure.
2. Program the PCM using the latest software matching the vehicle. Refer to up-to-date Techline equipment user's instructions.
3. If the PCM fails to program, proceed as follows:
^ Ensure that all PCM connections are OK.
^ Check the Techline equipment for the latest software version.
^ Attempt to program the PCM. If the PCM still cannot be programmed properly, replace the PCM. The replacement PCM must be programmed.

Functional Check
1. Perform the On-Board Diagnostic System Check.
2. Start the engine and run for one minute.
3. Scan for DTCs using the scan tool.