Checking Ignition Timing

Start engine and run at 3000 RPM with no loads and transmission in Park or Neutral, until radiator fan comes on. Allow engine to idle. Locate 2-pin service check connector (under glove box). Install Service Check Connector Tool (07PAZ-0010100 ), into service check connector. See Fig 1.
Connect timing light to service loop next to ignition coil No. 1 (White wire between ignition coil No. 1 and ignition control module).

Ensure idle speed is within specification. See IDLE SPEED . Red mark on crankshaft pulley should align with pointer on front of engine. See Fig 2. If timing is not as specified (Red mark and pointer are not aligned), replace ECM/PCM. Timing is not adjustable.

Fig 1: Installing Service Check Connector Tool

Courtesy of AMERICAN HONDA MOTOR CO., INC.

Fig 2: Ignition Timing Marks (Typical)

Courtesy of AMERICAN HONDA MOTOR CO., INC.

IGNITION TIMING ⁽¹⁾ (Degrees BTDC - RED MARK @ RPM)

Application

⁽²⁾ Man. Trans.

⁽³⁾ Auto. Trans.

3.2TL

13-17 @ 590-690

⁽¹⁾	Install Service Check Connector Tool (07PAZ-0010100 ) to service check connector before checking timing.

⁽²⁾	Manual transmission in "N".

⁽³⁾	Automatic transmission in "N" or "P".