Erasing DTC Memory Using SCS Service Connector
- Turn ignition off. Connect SCS Short Connector (07PAZ-0010100) to Memory Erase Signal (MES) connector. See Fig 1.
- Turn ignition on. SRS indicator light will come on for about 6 seconds then go off.
- Disconnect SCS short connector from MES connector within 4 seconds after SRS indicator light goes off. SRS indicator light will come on again.
- Reconnect SCS short connector to MES connector within 4 seconds after SRS indicator light comes on. SRS indicator light will go off.
- Disconnect SCS short connector from MES connector within 4 seconds. SRS indicator light will indicate that memory is erased by blinking 2 times.
- Turn ignition off, and wait 10 seconds before proceeding with troubleshooting.
Courtesy of ACURA