LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Acura >> 2000 >> Integra GS-R, 4D Sedan >> Repair and Diagnosis >> External Pages >> Different car >> Section 9 (Starters) >> On-Vehicle Testing >> Ignition Switch
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Ignition Switch

WARNING: This page is about a different car, the 2001 Acura MDX, 2001 Acura Integra, 2001 Acura 3.5RL, 2001 Acura 3.2TL, and 2001 Acura 3.2CL. However, it is still accessible from the selected car via links, so may be relevant.

Disconnect negative battery cable. Remove lower instrument panel cover and driver-side knee bolster. Disconnect 7-pin and 5-pin connector (Integra), 6-pin connector (3.2CL, 3.2TL and MDX) or 7-pin connector (3.5RL) from steering column harness. With ignition switch in appropriate position, check continuity between specified connector terminals. See Fig 1 -Fig 5 . If continuity is not as specified, replace ignition switch.

Fig 1: Testing Ignition Switch Continuity (Integra)
G00012266Courtesy of AMERICAN HONDA MOTOR CO., INC.
Fig 2: Testing Ignition Switch Continuity (3.2CL & 3.2TL Shown; MDX Is Similar)
G99I05313Courtesy of AMERICAN HONDA MOTOR CO., INC.
Fig 3: Testing Ignition Switch Continuity (3.5RL)
G00012262Courtesy of AMERICAN HONDA MOTOR CO., INC.
Fig 4: Ignition Switch Terminal Continuity Table (3.2CL, 3.2TL & MDX)
G99H05317Courtesy of AMERICAN HONDA MOTOR CO., INC.
Fig 5: Ignition Switch Terminal Continuity Table (3.5RL)
G00012263Courtesy of AMERICAN HONDA MOTOR CO., INC.
scientia non olet · About LEMON Manuals