Using Malfunction Indicator Light (MIL)
WARNING: This page is about a different car, the 2004 Acura 3.5RL, 2003 Acura 3.5RL, 2002 Acura 3.5RL, and 2001 Acura 3.5RL. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
If No. 56 BACK UP RADIO (7.5 amp) fuse is removed and ignition switch is turned ON (II), MIL will come on and PCM will store DTC P0560.
- Locate 2-pin Service Check Connector behind glove box. See Fig 1 . Install SCS Service Connector (07PAZ-0010100) to Service Check Connector. Turn ignition switch ON (II). Observe MIL. Light indicates a Diagnostic Trouble Code (DTC) by number of flashes.
- Single-digit trouble codes (1-9) are indicated by individual short flashes. Double-digit trouble codes (10-59) are indicated by a series of long and short flashes. The number of long flashes equals first digit; the number of short flashes equals second digit. If any DTCs are retrieved, see DIAGNOSTIC TROUBLE CODE DEFINITIONS .
- To determine if code is a hard or intermittent fault, clear PCM memory and recheck for code to appear. See PCM RESET PROCEDURE/CLEARING DIAGNOSTIC TROUBLE CODES . If codes other than those listed appear, temporarily substitute a known-good PCM and retest system.