Set/Resume/Cancel Switch Test: 3.2TL
- Disable air bag system. Remove steering column covers. Disconnect SET/RESUME/CANCEL switch 4-pin connector. See Fig 1.
- With SET button in ON position, continuity should exist between cable reel 4-pin connector terminals No. 2 and 4. See Fig 1. With RESUME button in ON position, continuity should exist between cable reel 4-pin connector terminals No. 2 and 3. With CANCEL button in ON position, check for continuity by probing cable reel 4-pin connector terminal No. 2 with positive terminal of DVOM, and terminals No. 3 and 4 with negative terminal of DVOM. With CANCEL button in ON position, continuity should exist between cable reel 4-pin connector terminals No. 2 and 4 and between terminals No. 2 and 3. If continuity exists as specified, go to next step. If continuity does not exist as specified, go to step 5.
- Remove instrument panel lower left cover and knee bolster. Disconnect in-line Blue 14-pin harness connector, located under left side of instrument panel, above driver's underdash fuse/relay box. Using DVOM, check for continuity in Light Green/Black wire between cable reel 4-pin harness connector terminal No. 3 and in-line 14-pin harness connector terminal No. 8. Also check for continuity in Light Green/Red wire between cable reel 4-pin harness connector terminal No. 4 and in-line 14-pin harness connector terminal No. 7. If continuity exists, go to next step. If continuity does not exist, replace wiring harness.
- Disconnect in-line 16-pin harness connector, located behind glove box. Using DVOM, check for continuity in Light Green/Blue wire between cable reel 4-pin harness connector terminal No. 2 and in-line 16-pin harness connector terminal No. 9. See Fig 2. If continuity does not exist, replace combination switch wiring harness.
- Remove SET/RESUME/CANCEL switch. See SET/RESUME/CANCEL SWITCH under REMOVAL & INSTALLATION. With SET button in ON position, continuity should exist between SET/RESUME/CANCEL switch connector terminals No. 1 and 3. See Fig 2. With RESUME button in ON position, continuity should exist between SET/RESUME/CANCEL switch connector terminals No. 1 and 2. Go to next step.
- With CANCEL button in ON position, check for continuity by probing SET/RESUME/CANCEL switch 4-pin connector terminal No. 1 with positive terminal of DVOM, and terminals No. 2 and 3 with negative terminal of DVOM. Continuity should exist at both circuits. If continuity does not exist as specified, replace switch. If continuity does exist, replace cable reel.
Courtesy of AMERICAN HONDA MOTOR CO., INC.
Courtesy of AMERICAN HONDA MOTOR CO., INC.