CKP Pattern Clear/CKP Pattern Learn (2005-2006 Models)
NOTE:
The ECT needs to be at 176°F (80°C) or higher.
- Clear the CKP PATTERN CLEAR with the HDS while the engine is stopped.
- Turn the ignition switch OFF.
- Turn the ignition switch ON (II), and wait 30 seconds.
- Test-drive the vehicle on a level road: decelerate (with the throttle fully closed) from an engine speed of 2,500 RPM to 1,000 RPM with the A/T 2nd gear in M position, or the M/T in 2nd or 3rd gear.
- Stop the vehicle. Do not turn the ignition off.
- Select the ALL DATA LIST in the DATA LIST MENU of the HDS.
- Check the status of PULSER F/B LEARN. If it is set to NG, the enable criteria was probably not met; repeat the procedure from the beginning.