LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Acura >> 2003 >> 3.2CL Base >> Repair and Diagnosis >> External Pages >> Different car >> Section 1 (Specifications & Procedures) >> Wheel Alignment Procedures >> Caster Adjustment >> 2.3CL, 3.0CL & 3.2TL
April 5, 2026: LEMON Manuals is launched! Read the announcement.

2.3CL, 3.0CL & 3.2TL

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2000 Acura Integra, 2000 Acura 3.5RL, 2000 Acura 3.2TL, 1999 Acura Integra, and 1999 Acura 3.5RL. However, it is still accessible from the selected car via links, so may be relevant.
  1. Check steering wheel position. If steering wheel is not centered, check toe-in adjustment. See TOE-IN ADJUSTMENT  . If toe-in adjustment is okay, remove and reinstall steering wheel on steering shaft splines in a straight ahead position.
  2. Caster angle can be adjusted by increasing or decreasing number of radius rod adjusting shims. Shims are .13" (3.3 mm) thick. Each shim will change caster adjustment .58 degree. Maximum correction is 1.17 degrees (2 shims).
  3. If caster adjustment is necessary, raise and support vehicle. Remove self-locking nut on end of radius rod. Remove radius rod flange bolts and remove radius rod. Install adjusting shim(s) on radius rod side of bushing. Tighten radius rod flange bolts and self-locking nut to specification. See TORQUE SPECIFICATIONS  . Ensure caster adjustment is within specification. See WHEEL ALIGNMENT SPECIFICATIONS  .
scientia non olet · About LEMON Manuals