Steering Lock Replacement

WARNING: This page is about a different car, the 2003 Acura 3.2CL, 2002 Acura 3.2CL, and 2001 Acura 3.2CL. However, it is still accessible from the selected car via links, so may be relevant.

Remove the steering column (see STEERING COLUMN REMOVAL AND INSTALLATION ).
Center punch each of the two shear bolts, and drill their heads off with a 5 mm (3/16 in.) drill bit. Be careful not to damage the switch body when removing the shear bolts.

Fig 1: Drilling The Shear Bolts
Courtesy of AMERICAN HONDA MOTOR CO., INC.
Remove the shear bolts from the switch body.
Install the switch body without the key inserted.
Loosely tighten he new shear bolts.
Insert the ignition key, and check for proper operation of the steering wheel lock and that the ignition key turns freely.
Tighten the shear bolts (A) until the hex heads (B) twist off.

Fig 2: Identifying The Shear Bolts
Courtesy of AMERICAN HONDA MOTOR CO., INC.