LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Acura >> 2003 >> MDX Base >> Repair and Diagnosis >> External Pages >> Different car >> Section 101 (Active Damper System) >> Vertical Acceleration Sensor Replacement >> Rear
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Vertical Acceleration Sensor Replacement: Rear

WARNING: This page is about a different car, the 2009 Acura MDX, 2008 Acura MDX, and 2007 Acura MDX. However, it is still accessible from the selected car via links, so may be relevant.
  1. Turn the ignition switch to LOCK (0).
  2. Remove the appropriate side of the rear side trim panel (see TRIM REMOVAL/INSTALLATION - REAR SIDE AREA ).
  3. Remove the sensor mounting nuts, and pull out the vertical acceleration sensor (A).
    NOTE: The illustration shows the left side of the vehicle, the right side is similar.
    Fig 1: Vertical Acceleration Sensor And Connector With Torque Specification
    G05486722Courtesy of AMERICAN HONDA MOTOR CO., INC.
  4. Disconnect the vertical acceleration sensor connector (B).
  5. Install the vertical acceleration sensor in the reverse order of removal.
  6. Test-drive the vehicle, and check that the active damper system indicator does not come on (see ACTIVE DAMPER SYSTEM DAMPER UNITS  ).
scientia non olet · About LEMON Manuals