Cruise Control Set/decel, Resume/accel, Cancel Switch Test/Replacement

SRS components are located in this area. Review the SRS component locations (see COMPONENT LOCATION INDEX ), and the precautions, and procedures (see PRECAUTIONS AND PROCEDURES ), before performing repairs or service.

1. Remove the two screws, then remove the switch.
   Fig 1: Removing Switch From SRS Component Locations

   Courtesy of AMERICAN HONDA MOTOR CO., INC.
2. Check for continuity between the terminals in switch position according to the table.
   • If there is continuity, and it matches the table, but switch failure occurred on the cruise control unit input test, check and repair the wire harness on the switch circuit.
   • If there is no continuity in one or both positions, replace the switch.
     Fig 2: Terminals Continuity Chart

     Courtesy of AMERICAN HONDA MOTOR CO., INC.