Mode 2 Test

From mode 1, disconnect the special tool from the multiplex inspection connector for 5 to 10 seconds, and then reconnect it.
The ignition key light and ceiling light should come on for 2 seconds, go out, then blink twice, 0.2 seconds each time. The system is now in Mode 2.

Operate the switches listed below: If the circuit is OK, the ignition key light and ceiling light will blink once. If the circuit is faulty, the lights will not blink.

Tip: Operating the switches most closely related to the problem you are diagnosing is a quick way of testing the circuits integrity.

MODE 2 TEST

Switch	Lights blink when:
Windshield washer switch	Washer switch pulled
Windshield wiper switch	Switch in the INT position
Driver's door switch	Driver's door is opened
Passenger's door switch	Passenger's door is opened
Hatch latch switch	Hatch is opened
Parking brake switch	Parking brake applied
Driver's door lock switch	Pushed to lock and unlock
Driver's door knob switch	Knob in UNLOCK or LOCK position
A/C switch	A/C switch ON and blower switch ON
Headlight switch	Switched to the PARK position
Brake pedal position switch	Brake pedal pressed
Transmission range switch	Shift P, R, D, D3 (A/T) Upshift then downshift (M/T)

If all inputs were confirmed, or multiple circuits failed at the same time in Mode 2, go to the MULTIPLEX SLEEP MODE TEST . If a single switch fails in Mode 2, troubleshoot its circuit.