DTC B1255: Combination Switch Control Unit Lost Communication With MICU
NOTE:
If you are troubleshooting multiple DTCs, be sure to follow the instructions in B-CAN system diagnosis test mode A (see
TROUBLESHOOTING - B-CAN SYSTEM DIAGNOSIS TEST MODE A ).
- Clear the DTCs with the HDS.
- Turn the ignition switch OFF, and then back ON (II).
- Check for DTCs with the HDS.
Is DTC B1255 indicated?
- YES - Go to step 4.
- NO - Intermittent failure, MICU is OK at this time. Check for loose or poor connection at combination switch control unit connector (8P), and at under-dash fuse/relay box connector X (39P). If the connections are good, check the battery condition (see BATTERY TEST ) and the charging system.
- Check for DTCs with the HDS.
Are DTCs B1055, B1157 and B1806 indicated?
- YES - Go to MICU INPUT TEST .
- NO - Replace the combination switch control unit.