Factory diagnostic screen "In Line Diag"

WARNING: This page is about a different car, the 2008 Acura TSX, 2007 Acura TSX, and 2006 Acura TSX. However, it is still accessible from the selected car via links, so may be relevant.

When a navigation unit is powered up for the first time at the factory, the "factory diagnosis" screen (In Line Diag) shows up. Normally the factory performs the steps necessary to verify proper operation and terminate the "factory diagnostic". Until the proper confirmation sequence is performed, the screen will show up every time the vehicle is started.

Fig 1: Factory Diagnostic Screen Display - In Line Diag

Courtesy of AMERICAN HONDA MOTOR CO., INC.

Follow the steps below to prevent the screen from showing up in the future:

Hold down the buttons (Menu + Map/Guide + Cancel) for about 5 seconds (the "Select Diagnosis Items" screen will appear)
Hold down the Map/Guide button for 5-10 seconds (A screen with a "Complete" button, will appear)
Touch "Complete", and then the "Return" button (the system may re-boot)
Restart the vehicle, and confirm normal operation by completing the "TQI of the navigation system" Service Bulletin.