Cruise Control Combination Switch Test/Replacement

SRS components are located in this area. Review the SRS component locations (see COMPONENT LOCATION INDEX ), and the precautions and procedures (see PRECAUTIONS AND PROCEDURES ), in the SRS before doing repairs or service.

1. Remove the driver's airbag (see DRIVER'S AIRBAG REPLACEMENT ).
2. Remove the steering wheel trim.
   Fig 1: Identifying Steering Wheel Trim And Bolts

   Courtesy of AMERICAN HONDA MOTOR CO., INC.
3. Remove the cruise control combination switch.
   Fig 2: Identifying Cruise Control Combination Switch Connector Terminals

   Courtesy of AMERICAN HONDA MOTOR CO., INC.
4. Check for continuity between the terminals in each switch position according to the table.
   • If there is continuity, and it matches the table, but switch failure occurred on the cruise control input test, check and repair the wire harness on the switch circuit.
   • If there is no continuity in one or more positions, replace the switch.
   Fig 3: Cruise Control Switch Position Terminals Continuity Chart

   Courtesy of AMERICAN HONDA MOTOR CO., INC.