LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Acura >> 2007 >> CSX Type-S >> Repair and Diagnosis >> External Pages >> Different car >> Section 56 (Power Window System) >> Rear Power Window Switch Test
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Rear Power Window Switch Test

WARNING: This page is about a different car, the 2011 Acura TL, 2010 Acura TL, and 2009 Acura TL. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the rear door panel (see REAR DOOR PANEL REMOVAL/INSTALLATION ), and disconnect the 14P connector from the switch
  2. Test the rear power window switch
    • When the power is connected to terminal No 2 and ground is connected to terminal No 14 There should be continuity between terminals No 8 and No 1
    • When the power is connected to terminal No 6 and ground is connected to terminal No 14 There should be continuity between terminals No 8 and No 7
    • When the power is connected to terminal No 8 and ground is connected to terminal No 14, then push the rear power window switch to DOWN There should be continuity between terminals No 8 and No 1
    • When the power is connected to terminal No 8 and ground is connected to terminal No 14, then pull the rear power window switch to UP There should be continuity between terminals No 8 and No 7
    Fig 1: Identifying Rear Power Window Switch Connector Terminals
    G05989022Courtesy of AMERICAN HONDA MOTOR CO., INC.
  3. If the continuity is not as specified, replace the switch (see Rear Power Window Switch Replacement )