Cruise Control Combination Switch Test/Replacement

There are SRS components located in this area. Review the SRS component locations (see COMPONENT LOCATION INDEX ), and the precautions and procedures (see PRECAUTIONS AND PROCEDURES ), in the SRS before doing repairs or service.

1. Remove the driver's airbag (see DRIVER'S AIRBAG REPLACEMENT ).
2. Disconnect the connectors, then remove the switch.
   Fig 1: Identifying Cruise Control Combination Switch Connector And Terminals

   Courtesy of AMERICAN HONDA MOTOR CO., INC.
3. Check for continuity between the terminals in each switch position (see Fig 2).
   • If there is continuity, and it matches the table, but switch failure occurred on the cruise control input test, check and repair the wire harness on the switch circuit.
   • If there is no continuity in one or both positions, replace the switch.
     Fig 2: Checking For Continuity Between Terminals In Each Switch Position

     Courtesy of AMERICAN HONDA MOTOR CO., INC.
4. Check for continuity between the terminals (see Fig 3).
   • If there is continuity, and it matches the table, check and repair the wire harness on the switch circuit.
   • If there is no continuity in one or more positions, replace the switch.
     Fig 3: Checking for continuity between terminals

     Courtesy of AMERICAN HONDA MOTOR CO., INC.