DTC B1032: MICU Lost Communication with the Gauge Control Module (CDS Message)
WARNING: This page is about a different car, the 2008 Acura TL and 2007 Acura TL. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
If you are troubleshooting multiple DTCs, be sure to follow the instructions in B-CAN System Diagnosis Test Mode A (see TROUBLESHOOTING - B-CAN SYSTEM DIAGNOSIS TEST MODE A
).
- Clear the DTC with the HDS.
- Turn the ignition switch OFF, and then back ON (II).
- Check for DTCs with the HDS.
Is DTC B1032 indicated?
YES -Go to step 4.
NO -Intermittent failure, the B-CAN communication line is OK at this time. Check for loose or poor connections. If the connections are good, check the battery condition (see BATTERY TEST ), and the charging system.
- Check for the DTCs with the HDS.
Is DTC B1000 also indicated?
YES -Troubleshoot DTC B1000.
NO -Replace the gauge control module.