Park Pin Switch Test
- Remove the center console (see CENTER CONSOLE REMOVAL/INSTALLATION ).
- Disconnect the transmission gear selection switch/park pin switch/A/T gear position indicator panel light connector.
- Shift the shift lever into P, then check for continuity between the connector terminals No. 1 and No. 4. There should be no continuity.
- Shift out of P, and check for continuity between the terminals No. 1 and No. 4. There should be continuity.
- If the park pin switch fails the test, replace it (see PARK PIN SWITCH TEST ).
- Install the center console (see CENTER CONSOLE REMOVAL/INSTALLATION ).