Wiper/Washer Switch Test/ Replacement
NOTE:
The wiper/washer switch is built into the combination switch control unit. For the wiper/washer test, refer to the WIPER/WASHER SWITCH INPUT TEST
.
- Remove the dashboard lower cover (see DRIVER'S DASHBOARD LOWER COVER REMOVAL/INSTALLATION ).
- Remove the steering column covers (see STEERING COLUMN REMOVAL AND INSTALLATION ).
- Disconnect the combination light switch 12P connector (A) and dashboard wire harness 8P connector (B) from the wiper/washer switch (C).
- Remove the two screws, then slide out the wiper/washer switch.