LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Acura >> 2007 >> TSX Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1 (Navigation System) >> Symptom Troubleshooting >> Voice control does not work/respond
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Voice control does not work/respond

WARNING: This page is about a different car, the 2005 Acura TSX and 2004 Acura TSX. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
  • Always check the connectors for poor connections or loose terminals.
  • Before troubleshooting, write down the audio presets, and get the audio and navigation system anti-theft codes.
  • After troubleshooting, enter the audio and navigation system anti-theft codes, and the audio presets.

Before assuming that a voice complaint is hardware related, ensure that the voice control system is being operated correctly.

  1. Go into the Diagnostic Menu and use the "Mic Level" test the under Functional Setup (see FUNCTIONAL SETUP  ) to check the operation of the TALK and BACK buttons.

    Are the TALK and BACK buttons operational? 

    YES  -Go to step 2.

    NO  -Check for an open or short to ground on navigation unit connector B (14P) terminal No. 10.

  2. Use the "Mic Level" diagnostic under Functional Setup (see FUNCTIONAL SETUP  ) to check the operation of the microphone.

    Is the microphone operational? 

    YES  -Check the operation of the voice control system (seethe Navigation System Manual).

    NO  -Check for a loose front map light (microphone) assembly. If OK, check for an open or short to ground on navigation unit connector B (14P) terminals No. 6 and No. 14.