How to End A Troubleshooting Session (Required After Any Troubleshooting)

How to End a Troubleshooting Session (required after any troubleshooting)

1. Reset the PCM with the HDS while the engine is stopped.
2. Do the PCM idle learn procedure.
3. Turn the ignition switch to LOCK (0).
4. Turn the ignition switch to ON (II), and wait for 30 seconds.
5. Turn the ignition switch to LOCK (0), and disconnect the HDS from the DLC.
6. Start the engine in P or N, and warm it to normal operating temperature (the radiator fan comes on).
7. To verify that the problem is repaired, test-drive the vehicle for several minutes at speeds over 30 mph (50 km/h) or under the same conditions as those indicated by the freeze data.