Passenger's Air Mix Control Motor Replacement

WARNING: This page is about a different car, the 2011 Acura TL, 2010 Acura TL, and 2009 Acura TL. However, it is still accessible from the selected car via links, so may be relevant.

Remove the passenger's dashboard undercover (see PASSENGER'S DASHBOARD UNDERCOVER REMOVAL/INSTALLATION )
Remove the glove box (see GLOVE BOX REMOVAL/INSTALLATION )
Release the wire from its harness clip (A), then remove the self-tapping screws and the passenger's heater duct (B)

Fig 1: Identifying Passenger's Heater Duct And Harness Clip
Courtesy of AMERICAN HONDA MOTOR CO., INC.
Disconnect the 5P connector (A) from the power transistor, and the 7P connector (B) from the passenger's air mix control motor (C) Remove the self-tapping screws and the passenger's air mix control motor from the heater unit

Fig 2: Identifying Passenger's Air Mix Control Motor And 7P Connector
Courtesy of AMERICAN HONDA MOTOR CO., INC.
Install the motor in the reverse order of removal Make sure the pin on the motor is properly engaged with the linkage After installation, make sure the motor runs smoothly