Driver's Under-dash Fuse/Relay Box (MICU) Removal/Installation: Installation

WARNING: This page is about a different car, the 2011 Acura TL, 2010 Acura TL, and 2009 Acura TL. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: The imoes unit is built into the driver's MICU which is part of the driver's under-dash fuse/relay box Further more, vehicles with the keyless access do the imoes certification by communicating with the remote slot control unit Because of this construction, the imoes must be registered, or the vehicle will not start

Install the relays and connect the connectors to the driver's under-dash fuse/relay box, then install the driver's under-dash fuse/relay box in the reverse order of removal
Install the removed parts in the reverse order of removal
Do the battery terminal reconnection procedure steps 1 to 4 (see BATTERY TERMINAL DISCONNECTION AND RECONNECTION )
Register the immobilizer system with the HDS
- With keyless access system (see KEYLESS ACCESS SYSTEM REGISTRATION )
- Without keyless access system (see IMMOBILIZER KEY REGISTRATION )
Do the remaining steps of battery terminal reconnection procedure (see BATTERY TERMINAL DISCONNECTION AND RECONNECTION )
Confirm that all systems work properly