Key Interlock Solenoid Test

WARNING: This page is about a different car, the 2011 Acura TL, 2010 Acura TL, and 2009 Acura TL. However, it is still accessible from the selected car via links, so may be relevant.

SRS components are located in this area Review the SRS component locations (see COMPONENT LOCATION INDEX ) and the precautions and procedures (see PRECAUTIONS AND PROCEDURES ) before doing repairs or service

Remove the steering column cover (see STEERING COLUMN COVER REMOVAL/INSTALLATION )
Disconnect the steering lock assembly connector
Turn the ignition switch to ACC (I)
Connect the positive battery terminal to steering lock assembly connector terminal No 4, and ground to steering lock assembly connector terminal No 3 Check that the ignition key cannot be turned to LOCK (0) Disconnect power, and check that the key can be turned to the LOCK (0) position and removed from the cylinder

Fig 1: View Of Steering Lock Assembly Connector
Courtesy of AMERICAN HONDA MOTOR CO., INC.
If the key interlock solenoid works improperly, replace the ignition key cylinder/steering lock assembly (see STEERING LOCK REPLACEMENT )