Steering Gearbox Removal and Installation: Notes

WARNING: This page is about a different car, the 2011 Acura TL, 2010 Acura TL, and 2009 Acura TL. However, it is still accessible from the selected car via links, so may be relevant.

Special Tools Required

Ball joint thread protector, 12 mm 07AAF-SDAA100
Ball joint remover, 28 mm 07MAC-SL0A202
Subframe alignment pin 070AG-SJAA10S
Attachment arm SIL02C000033 *
Engine hanger balance bar VSB02C000019 *
Front subframe adapter VSB02C000016 *
Engine support hanger, A and Reds AAR-T1256 *

* These special tools are available through the Acura Tool and Equipment Program, 888-424-6857

Note these items during removal

Use solvent and a brush, wash any oil and dirt off the end of the steering gearbox Avoid any electrical parts Blow dry with compressed air
Be sure to remove the steering wheel before disconnecting the steering joint, or damage to the cable reel can occur
Lower the front subframe from the body, and remove the steering gearbox through the gap produced by lowering the front subframe