Oil Jet Bolt Inspection
- Remove the oil jet bolt (see OIL JET REPLACEMENT ).
- Inspect the oil jet bolt as follows.
- Make sure that a 0.6 mm (0.02 in.) diameter drill will go through the oil intake (0.7 mm (0.03 in.) diameter). Make sure the check ball (A) moves smoothly and has a stroke of about 4.0 mm (0.16 in.)
- Check the oil jet bolt operation with an air nozzle. It should take at least 120 kPa (1.2 kgf/cm, 17 psi) to unseat the check ball.