LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Acura >> 2009 >> RL >> Repair and Diagnosis >> Transmission >> Automatic Trans >> Automatic Transmission >> Input Shaft (Mainshaft) Speed Sensor Replacement
July 1: So it begins. Don't worry, this is not in the correct legal jurisdiction!

Input Shaft (Mainshaft) Speed Sensor Replacement

  1. Do the battery removal procedure (see BATTERY REMOVAL AND INSTALLATION ).
  2. Remove the air cleaner (see THROTTLE BODY CLEANING ).
  3. Remove the battery base.
  4. Disconnect the input shaft (mainshaft) speed sensor connector, and remove the input shaft (mainshaft) speed sensor (A).
    Fig 1: Locating Input Shaft (Mainshaft) Speed Sensor Connector, And Input Shaft (Mainshaft) Speed Sensor With Torque Specifications
    G06164471Courtesy of AMERICAN HONDA MOTOR CO., INC.
  5. Install the new O-ring (B) on the new input shaft (mainshaft) speed sensor, then install the input shaft (mainshaft) speed sensor.
  6. Check the connector for rust, dirt, or oil, then connect the connector securely.
  7. Install the battery base.
  8. Install the air cleaner (see THROTTLE BODY CLEANING ).
  9. Do the battery installation procedure (see BATTERY REMOVAL AND INSTALLATION ).
scientia non olet · About LEMON Manuals